Description
The dice eyes are very good to touch and visible. They are slightly recessed so that the dice does not tilt on them. Due to the rounding of the corners, the dice rolls very well. Ideal on a soft surface made of felt, fabric or similar (e.g. dice board). The dice and the plates are printed separately and then glued together with a drop of super glue.
Printing instructions and tips
Dice The dice must be printed with about 5% filling. More filling makes the dice heavier, which makes it roll even better. Supporting structure on the bottom side is recommended, because then the platelet can be glued on better. Plates Ideally you change the filament after 0.4mm for a better contrast (I print the first layer with 0.3mm and then with 0.1mm - so change after layer 2). This technique is described here (headline “Multicolour printing by changing the filament”).
Downloads
- Main Asset (Dice_5.stl)
- Pasted Into Upload or Edit 3D-Model – additional_files (STL)
- Pasted Into Upload or Edit 3D-Model – additional_files (STL)
- Pasted Into Upload or Edit 3D-Model – additional_files (STL)
- Pasted Into Upload or Edit 3D-Model – additional_files (STL)
- Pasted Into Upload or Edit 3D-Model – additional_files (STL)
- Pasted Into Upload or Edit 3D-Model – additional_files (STL)
- Pasted Into Upload or Edit 3D-Model – additional_files (SKP)
- Pasted Into Upload or Edit 3D-Model – additional_files (STL)
- Dice (not for printing) (3MF)
Bundle of all files listed above.